I just finished putting this skimmer together and placed it on my 37 gallon column aquarium. First of all the positives. This skimmer is very quiet for a hob protein skimmer. I have my aquarium right next to my couch, and it doesn't distract from watching television. Very little microbubbles are released back into my aquarium, which should get even better with time. Since my aquarium is newly setup with no organisms yet, there is nothing to skim. However, there is a storm of bubbles in the skimmer column, and I know that this will do its job well when the time comes. And finally the pump doesn't sit inside the tank, saving you space and preventing excess heat entering your aquarium. You also don't have to worry about wandering anemones or small fish getting sucked up by this powerful pump.Now onto the negatives. If you are unfamiliar with how skimmers work, you might have trouble putting this together. Mainly the included directions are to blame, which are very little help to the user. Be sure that your o-rings are placed properly and the seals are screwed tight. Fill the skimmer with water before putting it in place and turning on, to check for leaks. The surface skimmer sits very low in the aquarium and if you like to fill your tank to the brim, the surface skimmer will not skim from the surface. Half an inch higher and it would be perfect.
Overall I'm very impressed with this skimmer, but there's a worry in the back of my mind that I'll come home to a wet floor.
Buy CoralVue Technology BH-1000 Octopus with External 1000 Pump for Aquarium Filter, 100-Gallon Now
This is my first skimmer (Efficiently speaking), It is a little bit difficult to adjust properly buy if you simply observe, there is no problem.I installed it, started the engine and moved sand sediments on my Tank and immediately i saw how the organic matter was expelled by the bubbles.
The major problem was the assembly as it did not include a manual installation or use. ONLY It just comes with a sheet with the explosive party. It was very useful to watch videos on sites like assembly on youtube for this model or the BH2000.I am using the BH-1000 skimmer on my 75 Gallon tank and it works great. I am also impressed at how well the "defoaming divice" works at preventing micro bubbles. It produces skim well and as far as performance and construction it's the best skimmer I have ever owned.
The only complaint I have is the intructions are lacking but thanks to the pluthera of You Tube videos on most Reef Octopus Skimmers this wasnt much of an issue.As soon as I bought this and put it together it started leaking from the connections. When I tightened it, the connector broke. Then the impeller packed it in. The seller was defensive and difficult. His response was "well nobody else seems to have these problems", and threatened to start adding on restocking charges if I left a bad review.
The distributor was nice enough, and they sent replacement parts but the unit still leaked. They eventually sent me a new pump, but that leaked too. 6 weeks later I finally cut my losses. It's now a boat anchor and it's on Craigslist AS IS. Went out and bought an AquaC Remora which was up and running in under an hour.
I bought this because it has good reviews. I apparently got a lemon, but in all honesty, there are just way too many pieces. Too many O rings, joints, connectors to break. This thing was cracking when I was assembling it. And I'm supposed to take it apart on a regular basis to clean it? Forget it. I wouldn't trust this not to leak all over my expensive wood flooring.
The only reason I gave it one star, was because for the 3 hours it did manage to work, it was skimming pretty good before it started leaking again.
Save 27% Off
0 comments:
Post a Comment